348 Specific loosening agent

348 Specific loosening agent

The addition can effectively improve the porosity and leveling of powder, prevent caking and gun blocking, promote atomization and improve the powder rate on the dead corner.

Product Information

Typical physicochemical data

The data provided on this data page is only typical values and not technical indicators of the product.

Particle size:         D50:3μm       D90:6μm

Supply form:         Micropowder

Storage and transportation

Store in a cool, dry and well-ventilated place.

Application

Powder coating

Product features and advantages

When the additive is added to the finished powder, it can loosen and prevent clumping and improve the powder fluidity. Effectively improve the phenomenon of powder spitting, gun blocking and "back edge" during powder spraying, and significantly increase the powder rate at dead corners; It can avoid agglomeration of fine powder and facilitate fine grinding. Effectively control the film thickness, which is conducive to thin coating uniformity.

Recommended dosage

0.1-0.5% additives are based on the total formula, due to different formulations and process conditions, it is recommended to determine the best amount of additives before use.

Adding method and processing guidance

The product is recommended to be added when the base material is premixed and then completely extruded. It can also be added to the sheet material mixed together with grinding and sifting, or added to the finished powder mixed and sifting.